The history of human understanding and use of drill bits can be traced back to prehistoric times. The stone drill used by the ancients to fire for wood can be regarded as the most primitive drill. The twist drill (commonly known as the drill....
The traditional notion that spiral groove drills are irreplaceable is now being overturned by the processing performance of straight groove drills. In some machining applications, straight groove drilling is becoming a better tool choice tha....
The PC needs an appropriate amount of cooling holes during operation, and the safety requires that the holes are not too large, posing an unnecessary danger. UL, CSA requires that the inner diameter of the round hole should not be greater t....
1. EMI (Electro Magnetic Interference) is electromagnetic interference. The mode of transmission is radiation and conduction. 2. Important regulations: FCC ( Federal Communication Commision) in the United States VDE (Verband Deutscher Electr....
ESD (Electrostatic Discharge) is an abbreviation for Electrostatic Discharge. The non-conducting body generates an electrostatic charge due to friction, heating or contact with other electrostatically charged bodies. When the electrostatic....
This standard is applicable to the inspection and acceptance of sheet metal processing cabinets and cabinet structural parts. It is a summary and supplement to the basic and routine technical requirements that are not exhaustively listed on....
Reasonable selection of tool materials is an important condition for high-efficiency machining of stainless steel. According to the cutting characteristics of stainless steel, the tool material is required to have good heat resistance, high....
The machinability of stainless steel is much worse than that of medium carbon steel. The cutting workability of the ordinary 45 steel is 100%, the relative machinability of the austenitic stainless steel 1Cr18Ni9Ti is 40%, the ferritic stain....
Tool rake angle g0: The hardness and strength of stainless steel are not high, but the plasticity and toughness are good, the heat strength is high, and the chips are not easily cut off during cutting. Under the premise of ensuring that the....