Copper precision turning parts. Material: C3604 fast cutting copper. Our company is good at turning all kinds of copper parts, various types of valve parts, electrical parts, copper nuts, mobile phone antenna, cylindrical knurling (straight/twill/nett....

TAG: Milling machining Turning Fasteners Screws Bolt Lathe processing Material Shaft machining 

Read more

The knurled shaft acts as a mechanical part that supports the rotating part and rotates with it to transmit the movement, torque or bending moment.....

TAG: Lathe processing Turning Milling machining Shaft machining Bolt Screws Fasteners 

Read more

Also known as hexagonal pillars, it is widely used in various circuit board assembly and electronic fields for computer connectors.....

TAG: Lathe processing Turning Milling machining Shaft machining Bolt Screws Fasteners 

Read more

Copper nuts, also known as embedded nuts and embedded copper nuts or plastic embedded nuts, are divided into hot-melt copper nuts, hot-pressed copper nuts, embedded copper nuts, and ultrasonic copper nuts according to different methods of us....

TAG: Lathe processing Turning Milling machining Shaft machining Bolt Screws Fasteners 

Read more

Pressure rivet nut, also known as flower shank nut, is fixed to the thin plate by means of riveting, and the pre-opening hole of the thin plate is placed above the nut and pressed directly into the thin plate through the press, thereby formi....

TAG: Lathe processing Turning Milling machining Shaft machining Bolt Screws Fasteners 

Read more

Securing the other end of the chassis sheet depends on it, The general material is carbon steel and stainless steel, the head type has a cross or slot to facilitate tool tightening, The left picture shows the eleven-character slot. If there ....

TAG: Lathe processing Turning Milling machining Shaft machining Bolt Screws Fasteners 

Read more

Summary The crankshaft is the central part of the internal combustion engine and is the heart of the engine. If its function cannot be accurately performed, the horsepower of the engine cannot be normally used. The relative angles of the cr....

TAG: Shaft machining Fasteners Programming CNC machining CNC Prototyping 

Read more

Figure 1-1 (a) parts drawing (b) Analysis of Parts Drawings The surface of the part is composed of a cylinder, a straight arc, an inverse arc, a cone, a groove, a thread, a hole, and the like. The dimensioning is complete. The blank is 45#....

TAG: Shaft machining Bolt Screws Fasteners Lathe processing Turning Material 

Read more

Hex nut is classified into I type, II type and thin type according to the nominal thickness. Nuts of class 8 or higher are type I and type II. The type I Hex nut is the most widely used, and the I nut is divided into A, B, and C grades. The....

TAG: Lathe processing Turning Shaft machining bolt Fasteners Screws Metal Products Manufacturer 

Read more

Stamping is a pressure processing method that uses a mold mounted on a press to apply pressure to a material at room temperature to cause separation or plastic deformation, thereby obtaining a desired part.....

TAG: Metal stamping Stamping die Mold manufacturer Programming Material Fasteners 

Read more