Reasonable selection of tool materials is an important condition for high-efficiency machining of stainless steel. According to the cutting characteristics of stainless steel, the tool material is required to have good heat resistance, high....
The machinability of stainless steel is much worse than that of medium carbon steel. The cutting workability of the ordinary 45 steel is 100%, the relative machinability of the austenitic stainless steel 1Cr18Ni9Ti is 40%, the ferritic stain....
This standard is applicable to the inspection and acceptance of sheet metal processing cabinets and cabinet structural parts. It is a summary and supplement to the basic and routine technical requirements that are not exhaustively listed on....
ESD (Electrostatic Discharge) is an abbreviation for Electrostatic Discharge. The non-conducting body generates an electrostatic charge due to friction, heating or contact with other electrostatically charged bodies. When the electrostatic....
1. EMI (Electro Magnetic Interference) is electromagnetic interference. The mode of transmission is radiation and conduction. 2. Important regulations: FCC ( Federal Communication Commision) in the United States VDE (Verband Deutscher Electr....
The PC needs an appropriate amount of cooling holes during operation, and the safety requires that the holes are not too large, posing an unnecessary danger. UL, CSA requires that the inner diameter of the round hole should not be greater t....
Small elastic modulus titanium alloy, small thermal conductivity coefficient of temperature, is a typical difficult materials, especially more difficult when cutting deep grooves. Figure 1 shows an example of machining a deep groove with a w....
With the continuous development of science and technology, in order to meet the special requirements of the performance of machine parts, some new materials with high strength, high toughness and high wear resistance are emerging. However, t....
Round insert milling cutters are suitable for milling titanium because their leading angles can be varied as appropriate. As long as these milling cutters are equipped with special inserts and the correct cutting parameters are applied, sta....