Vertical Lathe Cutting Steel Shaft Process Card

2019-05-19 16:39 Industry-news Views：

Cutting Steel Shaft Process Card

Kang Ding Hardware		Vertical Lathe Cutting Process Card	Product number		Part Number		Part Name		Number of pieces	page 1
			Mass production		CG004		Steel Shaft		1 item	1 page in total
Part processing route									Part specification
workshop D-7	Process								material	Q235 steel Φ25 round bar
Treasury	Blanking								weight	0.15 kg
turner	Deburring								Blank material size: Φ25×33mm
turner	Rough turning								Part technical requirements
turner	Finishing								1. no burrs on the surface.
turner	Deburring
Inspection room	test
No.	Step name	Device name	Equipment model	Tool number	Tool name			Process content	Unit working hours	Remarks
1	Alignment Clamping	Vertical Lathe	6140		Three-jaw chuck, chuck, tool holder wrench, etc.			The outer circumference of the clamping blank extends 50, and the clamping is aligned	2min
2	Turning end face, outer circle				90° outer circular knife, 45° elbow cutter			Turning end face, outer circle Φ24±0.05 to length 31	5min
3	drilling				Center drill Φ3, twist drill Φ12			Drilling Φ12 hole to long 31mm	10min
4	Cut off				Cutting knife			Center drill hole, deburring, cut to length 31	5min
5	Turning end face				45° elbow cutter			U-turn, Turning end face length 30 deburring	5min
6	test				0~150mm vernier caliper, 0~25mm micrometer, Plug gauge, etc.				5min
prepared by	Zou gold hair	Review		Approve		Sign			Date of preparation	2005.5

Industry-news