Special screws / Pin shaft
The knurled shaft acts as a mechanical part that supports the rotating part and rotates with it to transmit the movement, torque or bending moment.....
-
-
Isolated Hexagonal Columns
Also known as hexagonal pillars, it is widely used in various circuit board assembly and electronic fields for computer connectors..... -
Embedded nuts used in plastic products
Copper nuts, also known as embedded nuts and embedded copper nuts or plastic embedded nuts, are divided into hot-melt copper nuts, hot-pressed copper nuts, embedded copper nuts, and ultrasonic copper nuts according to different methods of us.... -
Press Riveting, Sheet Metal Fasteners
Pressure rivet nut, also known as flower shank nut, is fixed to the thin plate by means of riveting, and the pre-opening hole of the thin plate is placed above the nut and pressed directly into the thin plate through the press, thereby formi.... -
Captive Screws
Securing the other end of the chassis sheet depends on it, The general material is carbon steel and stainless steel, the head type has a cross or slot to facilitate tool tightening, The left picture shows the eleven-character slot. If there .... -
UG Software Platform Introduction
The Unigrahics NX/CAM CNC machining module consists of the following important components: 3D modeling, tool path design, tool path edit modification, machining simulation, post processing, CNC programming templates, cutting parameter librar.... -
Shaft Parts Process Plan Analysis
Figure 1-1 (a) parts drawing (b) Analysis of Parts Drawings The surface of the part is composed of a cylinder, a straight arc, an inverse arc, a cone, a groove, a thread, a hole, and the like. The dimensioning is complete. The blank is 45#.... -
Hex Nut Grade And Classification
Hex nut is classified into I type, II type and thin type according to the nominal thickness. Nuts of class 8 or higher are type I and type II. The type I Hex nut is the most widely used, and the I nut is divided into A, B, and C grades. The.... -
Turning A356 Cast Aluminum Alloy
Material: A356 casting aluminum alloy; Process: turning, drilling, reaming, tapping .... -
Turning Parts Processing
Turning is a machining process in which a cutting tool, typically a non-rotary tool bit, describes a helix toolpath by moving more or less linearly while the workpiece rotates. ....
