Engine lathe The engine lathe, one of the oldest metal removal machines, has a number of useful and highly desirable attributes. Today these lathes are used primarily in small shops where smaller quantities rather than large production runs....
Stainless steel processing technology example Stainless steel is widely used, and there are many examples of machining. Only a few examples of turning operations are given here for reference. 1. Turning: The workpiece material is 1Cr18Ni9Ti....
How to choose the grinding amount when grinding stainless steel? The speed of the ceramic bond grinding wheel is 30-35 m/s; The resin bond has a grinding wheel speed of 35 to 50 m/s. When surface burns are found, the wheel speed should be r....
What are the characteristics of grinding stainless steel? Stainless steel has high toughness and high heat strength, while the cutting edge of the grinding wheel has a large negative rake angle. During the grinding debris are not easily cut....
With the rapid development of aerospace, hydraulic, communications, micro-electronics, medical equipment and other industries. The Turning-Milling composite processing of many small precision composite parts with high precision, multi-batch....
Stainless steel parts tapping is much more difficult than tapping on common steel. Frequently, due to the large torque, the tap is “killed” in the screw hole, the tooth is broken or broken, the surface of the thread is not smooth, the groove is gr....
Frequently encountered problems when reaming stainless steel are: The surface of the hole is easy to be grooved, the roughness is poor, the aperture is out of tolerance, the bell mouth is formed, and the reamer is easy to wear. Different ty....
Twist drills are often used for drilling stainless steel workpieces. For hardened stainless steel, cemented carbide drills can be used, and super hard high speed steel or super fine grain cemented carbide drills can be used when conditions....
The characteristics of milling stainless steel are: The adhesion and fusion of stainless steel are strong, and the chips are easy to adhere to the cutter teeth, which deteriorates the cutting conditions; In reverse milling, the cutter teeth....
Due to the poor machinability of stainless steel, there is a higher requirement for the cooling, lubrication, penetration and cleaning performance of the turning fluid. Commonly used turning fluids have the following categories: 1. Sulfuriz....