This standard is applicable to the inspection and acceptance of sheet metal processing cabinets and cabinet structural parts. It is a summary and supplement to the basic and routine technical requirements that are not exhaustively listed on....
ESD (Electrostatic Discharge) is an abbreviation for Electrostatic Discharge. The non-conducting body generates an electrostatic charge due to friction, heating or contact with other electrostatically charged bodies. When the electrostatic....
1. EMI (Electro Magnetic Interference) is electromagnetic interference. The mode of transmission is radiation and conduction. 2. Important regulations: FCC ( Federal Communication Commision) in the United States VDE (Verband Deutscher Electr....
The PC needs an appropriate amount of cooling holes during operation, and the safety requires that the holes are not too large, posing an unnecessary danger. UL, CSA requires that the inner diameter of the round hole should not be greater t....
1 Scope and introduction 1.1 Scope This specification specifies the processing requirements that should be noted in the design of sheet metal structures. This specification applies to the processing requirements that must be observed in the....
Based on the stent bending blanking process and bending process, Comparative analysis of the process of forming three different stamping process (single processes, complex processes and continuous processes) confirm completion of the blankin....
Cold stamping is the application of pressure to a material by means of a die mounted on a press to cause separation or plastic deformation. Thereby obtaining a pressure method of the required parts (commonly known as stamping parts or punch....
Progressive die stamping is a cost-effective and safe method of producing components. Careful design and construction of dies will ensure optimum performance. A progressive die performs a series of fundamental sheet metal operations at two....
1. SUS304 (stainless steel): The most used stainless steel, because it contains Ni, is more resistant to corrosion and heat than Cr steel, and has low temperature strength, so the mechanical properties are very good. Very large work hardeni....
(Nickel Copper Alloy) Nickel Silver Alloy Nickel Silver Alloy: Refers to the general term for the alloy consisting of 50-70% copper and 15~35% nickel. Its material has excellent toughness, and its bright silver color and stability are su....