Cold stamping is the application of pressure to a material by means of a die mounted on a press to cause separation or plastic deformation. Thereby obtaining a pressure method of the required parts (commonly known as stamping parts or punch....
Progressive die stamping is a cost-effective and safe method of producing components. Careful design and construction of dies will ensure optimum performance. A progressive die performs a series of fundamental sheet metal operations at two....
1. SUS304 (stainless steel): The most used stainless steel, because it contains Ni, is more resistant to corrosion and heat than Cr steel, and has low temperature strength, so the mechanical properties are very good. Very large work hardeni....
(Nickel Copper Alloy) Nickel Silver Alloy Nickel Silver Alloy: Refers to the general term for the alloy consisting of 50-70% copper and 15~35% nickel. Its material has excellent toughness, and its bright silver color and stability are su....
SPCC (cold rolled steel): Cold rolled steel, hot rolled coil after acid pickling product is at ambient temperature workshop cold rolling until the thickness of 0.30-3.20mm, manufactured by electrolytic cleaning, annealing and quenching proce....
Chapter One Parts Introduction Parts analysis description 1. Parts shape and general requirements As shown in Figure 1-1, the material is stainless steel, the material thickness is 0.5mm, and the dimensional accuracy of the workpiece must m....
I still remember that when I studied the unicycle balance car in the corridor, after a whole week, more than one hour of practice per day was finally mastered. Since then has a cool skill. Learn to teach your friends in the future, it only....
Two-wheel electric balance car structure Perhaps many people still dont know much about the structure of the two-wheeled electric balance car, but dont worry, lets use a picture to clearly and concisely analyze the structure of the two-whee....
The shape and size of the car door glass lifter housing parts. As shown in Figure 8.2.1, The material is 08 steel plate, plate thickness 1.5mm, mass production. Stamping production, it requires the preparation of a stamping process. 8.2.1 P....
1) Determine the dimensions of the concave die. The blanking die adopts the integral concave die and the wire cutting machine tool. When arranging the position of the concave die on the die base, the pressure center and the handle center s....